![]() ![]() Note: Pressing TEXT after each ID entry will place the prompt on line three Enter the ID number, if necessary use the period for a hyphen. Press down until bank 0-0 appears at the top with Id no. While scanning press each numbered bank toĤ. Select out all banks except desired bank ie. If an ID was already stored, the bottom line will display ID was saved.ġ. Each bank has five 30 ID positions for a total of 150 per bank.Ģ. Is the the location position in the sub-bank, number 00 to 29.ġ. The ID is saved as x-xx, where the first x is the sub-bank number in the bank and the xx When the scanner stops on a conversion, Press Trunk, the bottom line will indicate where ![]() Note, for Type I or mixed Id’s see Programming Fleetmaps after this section. These are Identification assigned by the manager of the system you desire to scan. In OPEN mode, all others will be scanned and CLOSED mode only stored (see below) unlocked Note: The scanner will not stop on any TG id’s which are Locked-Out, OPEN or CLOSED modes. Press FUNC + 5 (Bank Open or Bank Closed will display). To change from Open Mode to Closed Mode (or the reverse).ġ. Press the number associated with desired bank. Pattern when turned on until Scan or manual is pressed.ġ. ![]() Note: If the radio was in search mode when turned off, the radio will continue that search Turn Radio on, the last bank(s) selected will start scanning. Note: Chart on page 48 for other text options. Presses up or down to move the courser back and fourth or to correct a mistake. Numbers PQRS and by selecting 1 is for the first of these four. The first letter is P, Press the number 7 then the number 1 for P. Example, POLICE DISP (11 characters counting the space) Using the numbered keys text in the line up to 12 characters. Press Text, the cursor appears on line 3.Ĥ. (upper left should read Mxxx for your bank and channel number)ģ. ![]() Press Manual, Press three digits to get the bank and channel number desired then Press Repeat steps 3, 4 and 5 until all are entered.ġ. Using the up/down, find the correct setting on line 4, usually Table, then ENTERģ. Using the up/down, find the correct Step on line 4, then ENTERħ. More than one trunk system may be stored in a bank, provided it is seperated by aįor VHF and UHF 400/500 additional steps must be set as follows:Ħ. Motorola requires only the control channels entered.ģ. EDACS frequencies are never programmed in the 00 channel inĪny bank and must be programmed in the correct listed LCN as listedĢ. Repeat steps 5 through 8 until all frequencies are entered in selected bank. Press MODE until Motorola or EDACS is displayed for the appropriate trunk type.Ĩ. Repeat steps 3, 4 and 5 then step 6Īgain until all desired frequencies are entered in selected bank.Ĥ. Press PGM, the scanner moves up one frequency slot. If needed, Press MODE to change the receiver mode.Ħ. Enter the frequency using the numbered keys in the format xx.xxxxx, xxx.xxxxx or xxxx.xxxxx.ĥ. Press PGM, (upper left should change from M to P)ģ. (Upper left should read Mxxx for your bank and channel number)Ģ. Press MANual, Press three digits to get the bank and channel number desired then Press Set the fleetmap in the last section prior to Programming.ġ. If system is Motorola Type II or EDACS start with Programming section, if Motorola Type I or IIi, ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |